Yes No Replace the hill missing parts (refer to the corresponding view of chapter 5 then go manual to Function Checks on page 2-6.
To adjust the bed to the EasyChair Automatic Chair position, press hill and hold the button (N) on the control pendant or control panel on a service flexible arm.
Replace the right hand pedal (refer to procedure.14 on page 4-48).5 The problem only occurs on the chair and TS functions.6 - 3 Storing the Bed.4 - 73 Head and Footboard.Page 2 - 42 AvantGuard Electric Bed Service Manual (QD1787).15 Bed Connected to AC Power, Brakes not Applied Detection Malfunction Chapter 2: Troubleshooting Procedures.Yes 1 2 No Go to RAP.4 on page 2-20.Carry out a full raise/lower cycle of the head section.Remove the headboard, then remove hill the hard surfaces of the SS and the.Adjust the elevation tool so as to lift the frame by a few centimetres.The chair function works (see Function Checks on page 2-6).If this solves the problem perform the Final Actions on page 2-12, otherwise contact manual your national Hill-Rom representative (see the last page of this manual).Yes 3 No Go to RAP.8 on page 2-29.7 The bed operates correctly with the new battery backup kit.For beds fitted with a 5th wheel system, use the 6 mm Allen key to remove the screw (A) securing the braking bar stop (B) (see figure 4-27 on page 4-54).1 - 23 Hard hill Surfaces on the Head, Seat, Thigh and Foot Sections. A spark is produced when it is connected, but is not hill dangerous for the power supply.C.
5 This solves the problem.
4 - 69 Siderail.
Yes No Replace the foot siderail support (refer to procedure.23 on page 4-72 then go to Function Checks on page 2-6.Carry out a hill full raise/lower cycle of the foot section by raising and manual lowering it manually when the lever tomtom has be used.Identify the assembly of the control panel on a flexible arm on the.4, avantGuard is a trademark of Hill-Rom Services, Inc.The power connector is correctly plugged into the power outlet.Page 2 - 38 AvantGuard Electric Bed Service Manual (QD1787).14 Emergency Trendelenburg Function not manual Working with lady the Bed not Connected to AC Power Chapter 2: Troubleshooting Procedures.14 Emergency Trendelenburg Function not Working with the Bed not Connected to AC Power 1 note: Identification.Using the T25 Torx key, loosen and remove the two screws (A) bomb securing the control lever subassembly (B) (see figure 4-33 on page 4-66).Failure to observe this warning could result in personal injury or equipment damage.
5 service manual bed hill rom - 15 Chapter 6: General Procedures Cleaning and Care.
All the screws, pins and circlips are secure and undamaged.
3 - 14 Lateral Caregiver Unit.